ZyXEL Communications IES-612-51A - Manual (Page 368)

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
368
52.2.11 SELT Diagnostic Get Command
Syntax:
ras> adsl linediag getselt
Use this command to display the status and the results of the SELT test on the specified port.
The report tells you what gauge of telephone wire is connected to the port and the approximate
length of the line measured both in meters and thousands of feet.
The following example displays the status and results SELT diagnostic results for DSL port 1.
52.2.12 Tone Diagnostics 992.3 Command
Syntax:
ras> adsl linediag toneDiag
Use this command to display the tone diagnostics for a port in the format defined in the ITU-T
G.992.3 standard. You do not need to use the line diagnostics set command first. Use the tone
diagnostics to analyze problems with the physical DSL line.
Figure 251 Line Diagnostics Get Command Example
ras> adsl linediag getselt 1
port inprogress cableType loopEstimateLength
---- -------------------- --------- ------------------
1 INPROGRESS 24AWG 0 m(0.00 kFt)
ras> adsl linediag getselt 1
port inprogress cableType loopEstimateLength
---- -------------------- --------- ------------------
1 DONE 24AWG 0 m(0.00 kFt)