ZyXEL Communications IES-612-51A - Manual (Page 223)

IES-612-51A User’s Guide
223
C
H A P T E R
3 3
Syslog
This chapter explains how to set the syslog parameters.
33.1 Syslog
The syslog feature sends logs to an external syslog server.
33.2 SysLog Screen
To open this screen, click Advanced Application, SysLog.
Figure 112 SysLog
The following table describes the labels in this screen.
Table 72 SysLog
LABEL DESCRIPTION
Enable Unix Syslog Select this check box to activate syslog (system logging) and then configure the
syslog parameters described in the following fields.
Syslog Server IP Enter the IP address of the syslog server. (The log facility is specified in Alarm >
Alarm Event Setup. See
Section 40.4 on page 251 .)
Apply Click Apply to save your changes to the IES-612-51A’s volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.