ZyXEL Communications IES-612-51A - Manual (Page 315)

Chapter 47 IGMP Commands
IES-612-51A User’s Guide
315
where
This command sets a DSL port(s) to use an IGMP filter profile.
The following example sets DSL port 5 to use the voice IGMP filter profile.
47.3.3 IGMP Filter Profile Set Command
Syntax:
ras> switch igmpfilter profile set
where
This command configures an IGMP filter profile.
The following example configures an IGMP filter profile named voice with a range of
multicast IP addresses (index 1) from 224.1.1.10 to 224.1.1.44.
47.3.4 IGMP Filter Profile Delete Command
Syntax:
ras> switch igmpfilter profile delete
where
[|*] = You can specify a single DSL port <1> or all DSL ports
<*>.
= The name of an IGMP filter profile.
Figure 175 IGMP Filter Set Command Example
ras> switch igmpfilter set 5 voice
= Specify a name to identify the IGMP filter profile (you
cannot change the name of the DEFVAL profile). You can
use up to 31 ASCII characters; spaces are not allowed.
= The number (1~16) to identify a multicast IP address range.
= Type the starting multicast IP address for a range of
multicast IP addresses that you want to belong to the IGMP
filter profile.
= Type the ending multicast IP address for a range of IP
addresses that you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in
both the Start IP and End IP fields.
Figure 176 IGMP Filter Profile Set Command Example
ras> switch igmpfilter profile set test1 1 224.1.1.10 224.1.1.44
= The name of an IGMP filter profile.