beautypg.com

3 packet filter pppoe only command, Figure 192 packet filter set command example – ZyXEL Communications IES-612-51A User Manual

Page 329

background image

Chapter 48 Packet Filter Commands

IES-612-51A User’s Guide

329

The following example sets DSL port 5 to reject ARP, PPPoE and IGMP packets.

48.1.3 Packet Filter PPPoE Only Command

Syntax:

ras> switch pktfilter pppoeonly

This command sets the IES-612-51A to allow only PPPoE traffic on the specified DSL port(s).
The system will drop any non-PPPoE packets.

The following example sets DSL port 1 to accept only PPPoE packets.

Figure 192 Packet Filter Set Command Example

ras> switch pktfilter set 5 arp pppoe igmp

Figure 193 Packet Filter PPPoE Only Command Example

ras> switch pktfilter pppoeonly 1

See also other documents in the category ZyXEL Communications Hardware: