ZyXEL Communications IES-612-51A - Manual (Page 231)

Chapter 34 Access Control
IES-612-51A User’s Guide
231
Figure 117 Remote Management (Secured Client Setup)
The following table describes the labels in this screen.
Table 78 Remote Management (Secured Client Setup)
LABEL DESCRIPTION
Return Click Return to go back to the previous screen.
Index This is the client set index number. A “client set” is a group of one or more
“trusted computers” from which an administrator may use a service to manage
the IES-612-51A.
Enable Select this check box to activate this secured client set. Clear the check box if
you wish to temporarily disable the set without deleting it.
Start IP Address
End IP Address Configure the IP address range of trusted computers from which you can
manage the IES-612-51A.
The IES-612-51A checks if the client IP address of a computer requesting a
service or protocol matches the range set here. The IES-612-51A immediately
disconnects the session if it does not match.
Telnet/FTP/Web/
ICMP Select services that may be used for managing the IES-612-51A from the
specified trusted computers.
Apply Click Apply to save your changes to the IES-612-51A’s volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.