ZyXEL Communications IES-612-51A - Manual (Page 349)

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
349
where
This command records the telephone number of a DSL subscriber telephone number.
The following example records the telephone number 12345678 for DSL port 5.
52.1.10 DSL Port Loopback Command
Syntax:
ras> adsl loopback < f5>
where
This command has the IES-612-51A perform an OAMF5 loopback test on the specified DSL
port(s).
The following example has the IES-612-51A perform an OAMF5 loopback test on DSL port
1’s PVC at VPI 0 and VCI 33.
52.1.11 DSL Port Upstream PSD Command
Syntax:
ras> adsl usnompsd []
= You can specify a single DSL port <1>, all DSL ports <*> or
a list of DSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
= a DSL subscriber’s telephone number. You can use up to 15
ASCII characters (including spaces and hyphens).
Figure 221 DSL Port Tel Command Example
ras> adsl tel 5 12345678
= You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
< f5> = Use f5 to perform an OAMF5 loopback test on the specified
DSL port. An Operational, Administration and Maintenance
Function 5 test is used to test the connection between two
DSL devices. First, the DSL devices establish a virtual
circuit. Then the local device sends an ATM F5 cell to be
returned by the remote DSL device (both DSL devices must
support ATM F5 in order to use this test).
= When you perform an OAMF5 loopback test, specify a VPI/
VCI.
Figure 222 DSL Port Loopback Command Example
ras> adsl loopback 1 f5 0 33
port[1] OAM F5 loopback test: failed