ZyXEL Communications IES-612-51A - Manual (Page 371)

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
371
52.3.2 Alarm Profile Set Command
Syntax:
ras> adsl alarmprofile set [
fast rateup>
rateup>
]
where
= A name for the alarm profile (up to 31 ASCII characters).
atuc = Upstream. These parameters are for the connection (or
traffic) coming from the subscriber’s device to the IES-612-
51A.
atur = Downstream. These parameters are for the connection (or
traffic) going from the IES-612-51A to the subscriber’s
device.
= The number of Loss Of Frame seconds that are permitted to
occur within 15 minutes.
= The number of Loss Of Signal seconds that are permitted to
occur within 15 minutes.
= The number of Loss Of Link seconds that are permitted to
occur within 15 minutes.
= The number of Loss of Power seconds that are permitted to
occur (on the ATUR) within 15 minutes.
= The number of Errored Seconds that are permitted to occur
within 15 minutes.
rateup>
fast rateup>
= A rate in kilobits per second (kbps). If a fast mode
connection’s upstream transmission rate increases by more
than this number, then a trap is sent.
interleave
rateup>
interleave
rateup>
= A rate in kilobits per second (kbps). If an interleave mode
connection’s upstream transmission rate increases by more
than this number, then a trap is sent.
ratedown>
fast ratedown>
= A rate in kilobits per second (kbps). If a fast mode
connection’s downstream transmission rate decreases by
more than this number, then a trap is sent.
interleave
ratedown>
interleave
ratedown>
= A rate in kilobits per second (kbps). If an interleave mode
connection’s upstream transmission rate decreases by more
than this number, then a trap is sent.
enable>
= “1” sets the profile to trigger an alarm for an initialization
failures trap. “2” sets the profile to not trigger an alarm for
an initialization failures trap.