ZyXEL Communications IES-612-51A - Manual (Page 342)

Chapter 51 SNMP Commands
IES-612-51A User’s Guide
342
where
Use this command to add the host IP address to the list of trusted hosts. If you enter a trusted
host, your IES-612-51A will only respond to SNMP messages from this address. If you leave
the trusted host set to 0.0.0.0 (default), the IES-612-51A will respond to all SNMP messages it
receives, regardless of source.
51.1.4 Trap Community Command
Syntax:
ras> sys snmp trapcommunity
where
Enter this command with the community to set the password.
51.1.5 Trap Destination Set Command
Syntax:
ras> sys snmp trapdst set []
where
Use this command specify the IP address (and port number) of a trap server to which the IES-
612-51A sends SNMP traps. If you leave the trap destination set to 0.0.0.0 (default), the IES-
612-51A will not send any SNMP traps.
51.1.6 Show SNMP Settings Command
Syntax:
ras> sys snmp show
This command displays the current SNMP get community, set community, trap community,
trusted hosts and trap destination settings.
= The IP address of a trusted host.
= The password sent with each trap to the SNMP manager.
= The number of the trap server (1~4).
= The IP address of the trap server.
[] = The port number upon which the trap server listens for
SNMP traps. The IES-612-51A uses the default of 162 if
you do not specify a trap port.