ZyXEL Communications IES-612-51A - Manual (Page 310)

Chapter 46 MAC Commands
IES-612-51A User’s Guide
310
46.3 MAC Count Commands
Use MAC count commands to limit how many MAC addresses may be dynamically learned.
MAC count commands are listed next. When the MAC filter accept mode is enabled (see
Section 46.2 on page 307 ), the IES-612-51A ignores the MAC count setting and accepts all of
the MAC addresses listed for the port in the MAC filter settings.
46.3.1 MAC Count Show Command
Syntax:
ras> switch mac count show [portlist]
where
This command displays the MAC count settings on the specified DSL port(s) or on all DSL
ports if no port is specified.
The following example displays the MAC count settings for DSL port 4.
46.3.2 MAC Count Enable Command
Syntax:
ras> switch mac count enable
where
This command enables the MAC count filter on the specified DSL port(s). When the MAC
filter accept mode is enabled (see
Section 46.2 on page 307 ), the IES-612-51A ignores the
MAC count setting and accepts all of the MAC addresses listed for the port in the MAC filter
settings.
The following example turns on the MAC count filter on DSL port 4.
[portlist] = You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
Figure 167 MAC Count Show Command Example
ras> switch mac count show 4
port status count
---- ------ -----
4 V 128
= You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
Figure 168 MAC Count Enable Command Example
ras> switch mac count enable 4