Oki B4100 - Manual (Page 415)

40055101TH Rev.4 415 /
A3.2.11 M17 Circuit Diagram (Page 12/17)
1. Block diagram
The circuit diagram shown on page 12/17 consists of the following functions and connectors:
•
IC9 (Drum motor driver)
• IC22 (Resist motor driver)
• Connector CN3 that provides an interface between M17 board and the resist motor.
• Connector CN4 that provides an interface between M17 board and the drum motor.
Figure A3.2.14 shows the related signals of the drum motor and resist motor.
2. Function
1) Drum motor control
The drum motor is driven by the motor driver IC9. It is two-phase excited and bipolar-
driven according to the DMPH1 and DMPH2 signals that are generated from the CPU.
The DMON2-N, DMENA-N signal are generated from CPU. This drum motor rotates the
image drum.
2) Resist motor control
The resist motor is driven by the motor driver IC22. It is two-phase excited and bipolar-
driven according to the RMPH1 and RMPH2 signals that are generated from the CPU. The
RMON1-N, RMON2-N signal ARE generated from CPU. This resist motor rotates the
hopping (paper hopping) roller and the resist (paper feed) roller.
Refer to Appendix B of the page B-3.
Figure A3.2.14 Related Signals of Drum/Resist Motor
M
M
CN4
CN3
1
2
3
4
1
2
3
4
DM-T1
DM-T2
DM-T3
DM-T4
RM-T1
RM-T2
RM-T3
RM-T4
(2 phase excitation)
Resist motor
drive
Drum motor
Resist motor
M17
Drum motor
drive
(2 phase excitation)
IC9
IC22
CPU
DMPH1
DMPH2
DMENA-N
DMON2-N
RMON1-N
RMPH2
RMPH1
RMON2-N