Oki B4100 - Manual (Page 317)

40055101TH Rev.4 317 /
7.2.20 Document Skew
Start
No
Are the document guides set to meet the
document width?
Are the documents straightly loaded along
the guides?
The documents have
the same width?
1. Set the guides to meet the
document width.
2. Load the documents
straight along the guides.
No
No
Yes
A
< 0.08 to 0.13 mm (Multiple doc.)?
< 0.06 to 0.15 mm (Single doc.)?
Load documents by meeting
the same width.
Check points:
1. Adhesive such as paste, tape, etc. on the
surface of the documents?
2. The leading edges of the documents are
rugged due to paste, etc.?
Yes
The thickness of the document:
The documents are
normal?
The control panel unit is closed firmly?
Are there obstacles such as pieces of
paper in the document-passing slot?
Use the carrier sheet.
Use documents of the left
specification.
Close the control panel unit.
Remove the obstacles.
Replace the rugged parts.
Is the document-passing slot rugged
due to flaws, etc.?
Yes
No
No
Yes (Normal)
Yes
No
No
Yes
Yes