Oki B4100 - Manual (Page 110)

40055101TH Rev.4 110 /
P.F.
Item Specifications Default
No.
Table 2.9.4 (2/4) User's Initial Settings (Function Program)
The fax compares lower four digits of TSI/CSI re-
ceived from remote station with fax numbers regis-
tered locally for one-touch dial and two-digits autodial.
If unmatched, the communication will be automati-
cally disconnected.
OFF/RX only/TX and RX selectable.
* Prevention of direct mail or wrong number calls.
(Reference)
TSI:
Transmitting subscriber identification
CSI: Called subscriber identification
Selects automatically the mode set up when a docu-
ment is loaded on the feeder.
The following combinations are selectable.
STD/NORMAL
→
STD/DARK
→
STD/LIGHT
→
FINE/NORMAL
→
FINE/DARK
→
FINE/LIGHT
→
EX.FINE/NORMAL
→
EX.FINE/DARK
→
EX.FINE/LIGHT
→
PHOTO/NORMAL
→
PHOTO/DARK
→
PHOTO/LIGHT
→
STD/NORMAL
→
• • •
Specifies the time for which the fax alerts an operator
on reception of a call in the telephone/fax automatic
swichover mode.
20 sec./35 sec. selectable
Refer to page 2-36
User can register ring response time if National code is:
INT’L, GBR, NOR, SWE, USA, HOL, ESP. ITA,
GRE or GER
Selects the ring response time.
1 ring/5/10/15/20 sec. selectable.
Specifies the detected distinct ring. (not available in all
countries)
OFF/ON/SET selectable.
Selects A4, LETTER or LEGAL 13˜, LEGAL 14˜/
OTHER (when installing Bi-Centro board) by this
function.
The operator must select the preferable paper size as
the machine cannot detect the paper size automati-
cally.
08 Closed network
09 TX mode default
10 Telephone/fax automatic switchover
time
11 Ring response time
12 Distinct ring
13 1’st cassette paper size
Rev.3