Ricoh AP4510 - Manual (Page 381)

Using the Installation Shell Script
5
1
GGGG
Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the
{{{{RETURN}}}} key. Enter a new
name, if you want to use a different one.
Note
❒ The host name entered in step F followed by “_prn” appears in “default”.
HHHH
Set the print option.
Enter remote printer name [default lp]:
• Press the
{{{{RETURN}}}} key, print with PCL or PostScript is enabled.
• If you want to set the device option, enter the option parameter.
Enter remote printer name [default lp]:tray=tray1
For more information about the device option, see p.16 “Specifying the De-
vice Option”.
• If you enter “text”, text printing is enabled.
If you enter “text”, printing with PCL and PostScript is unavailable.
Enter remote printer name [default lp]:text
Limitation
❒ You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red
Hat Linux 7.0, and 51 for Red Hat Linux 6.2.
❒ When printing with the lp command, use ( _ ) instead of ( = ) and ( ; ) in-
stead of ( , ) for operating systems that cannot use ( = ) and ( , ) such as So-
laris 2.5 or later.
After the setup with the installation shell script is complete, and if you enter
the IP address in step
E , the following message appears.
hosts file is modified
IIII
Perform a test print to make sure that the settings are correct.
# lpr -Pnp file_name
# lp -d np file_name
For more information about lpr and lp, see p.11 “Printing Method”.