Ricoh AP4510 - Manual (Page 130)

Troubleshooting
56
5
❖ ❖ ❖ ❖ Alert Messages
Messages/Second messages Description Solution
Add Staples The staples are almost run
out. Replace the staple refill with a
new one. See p.91 “Adding
Staples”.
Call Service: EC
Power Off On
/If Error Reoccur
Call Service
An error has occurred in the
printer. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Change Setting
Bypass Tray
/Paper Size
Paper Type
The paper type and size set-
ting on the tray differs from
that of actual paper type and
size in the tray. Load { paper size and type }
paper with the selected feed
direction into tray. Printing
will not automatically resume
if the paper type, size and di-
rection setting is incorrect.
There are two methods to
resume printing.
A Use the control panel to set
the correct paper type, size
and direction of the paper
in tray.
B Press {{{{Form Feed}}}} and se-
lect the tray with the con-
trol panel.
Change Setting
LCT
/Paper Size
Paper Type
The paper type and size set-
ting on the tray differs from
that of actual paper type and
size in the tray. Load { paper size and type }
paper with the selected feed
direction into tray. Printing
will not automatically resume
if the paper type, size and di-
rection setting is incorrect.
There are two methods to
resume printing.
A Use the control panel to set
the correct paper type, size
and direction of the paper
in tray.
B Press {{{{Form Feed}}}} and se-
lect the tray with the con-
trol panel.