Ricoh AP4510 - Manual (Page 105)

Paper and Other Media Supported by This Printer
31
3
• Load only one size and type of envelope at a time.
• Do not forcibly push envelopes when loading.
• Confirm that the top of the stack is not higher than the limit mark inside
the tray.
• Use flat envelopes with no curl. If they have a curl, flatten them.
• Use completely flat envelopes that contain no air inside.
• Do not print on both sides of envelopes.
• Do not use the following envelopes:
Envelopes with multiple flaps
Envelopes with a peel-off adhesive strip
Envelopes with windows or clasps
Envelopes made of paper that is not supported by this printer (See p.31
“Paper not supported by this printer”)
Envelopes with a large flap (Envelopes with a flap length longer than half
the length of the envelope side)
• We recommend setting the margins to at least 15 mm (0.6 inch) for all four
directions.
• Envelopes are output to the standard output tray only.
• Envelopes may wrinkle or print quality may be poor depending on the
characteristics of the envelope such as weight and stiffness.
• See p.25 “Paper Sizes” for the supported sizes of envelopes.
❖ ❖ ❖ ❖ Paper not supported by this printer
Avoid using the following paper.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
• Paper that has already been printed onto, except a preprinted letterhead
• Coated paper