Ricoh AP4510 - Manual (Page 301)

61
5. Macintosh Configuration
Configuring Macintosh
This section describes how to configure a Macintosh computer to use EtherTalk.
The actual procedures to configure a Macintosh may vary depending on the ver-
sion of the Mac OS. The following procedure describes how to configure Mac OS
9.1. If you are not using Mac OS 9.1, see the manual that comes with your version
of Mac OS for more information.
Changing to EtherTalk
The following procedure is for configuring a Macintosh computer to use
EtherTalk.
Reference
For more information about installing the software required for EtherTalk,
see the Macintosh manuals.
AAAA
Open [Control Panel], and then double-click the [AppleTalk] icon.
BBBB
From the [Connect via:] pop-up menu, select “Ethernet”.
CCCC
If you change zones, select a name from the [Current zone:] pop-up menu.
DDDD
Close the [AppleTalk] control panels.
EEEE
Restart the Macintosh.
Change to EtherTalk
Basic Procedure
Configure the printer
Change the printer name
Change the zone