Ricoh AP4510 - Manual (Page 231)

iii
This manual contains detailed instructions on configuring the machine as a net-
work printer. Read the section appropriate to your network environment on
how to configure the machine correctly.
Important
❒ The procedures written in this manual assume that you are a network admin-
istrator. If you are not, be sure to consult your network administrator before
configuration.
Reference
For more information about configuring the Network Interface Board with
the control panel, see the Setup Guide.
❖ ❖ ❖ ❖ Features
• Support for 100BASE-TX, 10BASE-T and IP over 1394
• The Network Interface Board is compatible with NetWare (IPX/SPX,
TCP/IP), Windows NT 4.0 (TCP/IP, NetBEUI *1 , IPP *2 ), Windows 2000
(TCP/IP, NetBEUI *1 , IPP *2 ), Windows 95/98/Me (TCP/IP, NetBEUI *1 ,
IPP *2 ), UNIX (TCP/IP) and Macintosh (AppleTalk) protocols. This allows
you to use the machine in a network that uses different protocols and op-
erating systems.
• A computer used as a dedicated print server is not required because the
Network Interface Board can be configured as a NetWare print server.
• The Network Interface Board can connect the machine to the network
without requiring its own power supply because the Network Interface
Board is installed inside the machine.
*1 To use NetBEUI, use the SmartNetMonitor for Client port.
*2 IPP (Internet Printing Protocol) is a protocol for printing via the Internet.
NetWare (Server)
Windows NT (Server)
Windows 2000,
Windows 95/98/Me
Macintosh
NetWare
(Client)
Windows NT
Windows 2000
UNIX