Ricoh AP4510 - Manual (Page 141)

Error & Status Messages on the Control Panel
67
5
Getting Printer Information over the Network
Printer current status
You can check the printer's status using the telnet command.
❖ ❖ ❖ ❖ telnet
Use the stat command.
❖ ❖ ❖ ❖ UNIX
Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.
Reference
For more information, see “Remote Maintenance by telnet” in the Network
Printing Guide on the CD-ROM labeled “Operating Instructions”.
Messages Description Solution
Call Service Center: SC An error has occurred in the
printer. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Cover Open: Bridge The cover of the Bridge Unit is
open. Close the cover.
Cover Open: Duplex Unit The cover of the optional Du-
plex Unit is open. Close the cover of the optional
Duplex Unit.
Close Open: Finisher The cover of the Finisher
SR730 is open. Close the cover.
Cover Open: Front Cover The front cover of the printer
is open. Close the front cover.
Cover Open: Lower Right
Cover The lower vertical paper feed
cover is open. Close the cover.
Cover Open: Mailbox The cover of the Mailbox is
open. Close the cover.
Cover open: Right Cover The upper vertical paper feed
cover is open. Close the cover.
Empty: Toner The printer is out of toner. Replace with a new toner bot-
tle.
Energy Saver Mode The printer is in Energy Saver
Mode. No action is required.
Error: DIMM An error has occurred in the
printer. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Error: Ethernet An error has occurred in the
Ethernet Board. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.