HP 8360 - Manual (Page 71)

Note U, V, and W-band power sensors are not available from
Hewlett-Packard. For these frequencies use the Anritsu
Power Meter with the
(40 to 60 the
(50 to 75 or the (75 to 110 power sensors. Since
the Anritsu model Power Meter is not capable of internally
storing power sensor cal factors, you must manually correct the
data entry. Refer to example 2 for information on manual entry of
correction data.
5.
6.
7.
8.
9.
10.
11.
12.
Setup Synthesizer Parameters
Turn on the synthesizer and press
The following occurs:
n The source module’s frequency span is displayed on the
synthesizer.
n The synthesizer’s leveling mode is automatically changed
internal to “module leveling”.
n The source module’s maximum specified power is set and
displayed.
from
Press FREQUENCY (START)
The frequency sweep is set from 26.5 to 40
Press The source module power is set to
for maximum power to the device under test.
Access User Flatness Correction Menu
Press POWER Select Fltness Menu.
Select Delete Menu Delete All. This step insures that the
flatness array is empty.
Press Leave the delete menu and return to the previous
menu.
Select Enter Freq to enter 26.5 as
the first correction frequency. Enter 31, 32.5, and 40 to
complete the list. Notice that the frequencies are arbitrarily
spaced.
Enter Correction Data into Array
Select Mtr Menu Measure All. The power meter
is now under synthesizer control and is performing the sequence
of steps necessary to generate the correction information at each
frequency point.
If an HP-IB error message is displayed verify that the interface
connections are correct. Check the HP-IB address of the power
meter and ensure that it is the same address the synthesizer is
Getting Started Advanced 1-41