HP 8360 - Manual (Page 195)

S t a t u s
Table D-l.
Mnemonics used to Indicate Status (continued)
Function Mnemonic
Flatness On/Off
Start Sweep Trigger
Power Slope Rf Slope
Power Sweep Pwr Swp
Sweep Mode
Peak RF Always
AM BW Cal Always
Cal Always
State
Off
On
Automatic
HP-IB
External
Off
On
Off
On
Ramp
Step
List
c w
On
On
On
Mnemonic
Off
On
Auto
Bus
Ext
Off
On
Off
On
Swept
Step
List
c w
Zero Span
Peaking or
Peak
AM BW or
or
Am
or
Freq or Frq
Programming Codes SCPI: NONE
Analyzer: NONE
See Also STATUS MESSAGES
Amp Mode AUTO
Function Group POWER
Menu Map
Description This is applicable to instrument models with a doubler
installed. The doubler has an integral amplifier whose operation
is controlled by the instrument firmware. The use of the amplifier
depends on the frequency of operation and on the calibration
constants set at the factory. The instrument defaults after preset to
this automatic mode of operation which is the specified operation.
This
has no effect on instruments without a doubler.
An asterisk next to the key label indicates that this feature is active.
This feature is the default after preset.
Operating and Programming Reference HP 8360
User’s Handbook