HP 8360 - Manual (Page 430)

Language Selection You can operate the synthesizer using one of three external interface
languages: SCPI, Analyzer language, or CIIL (Option 700).
How to View or Change a Language Selection from the Front Panel
Note To set a programming language from the front panel, the instrument
language on the rear panel HP-IB switch and Figure 3-2)
be set to 7 (all
The HP-IB menu provides access to the synthesizer’s programming
language:
1. Press SYSTEM
2. Select HP-IB Menu.
3. The synthesizer displays the three language
softkeys: Programming Language SCPI ,
Programming Language
Language . An asterisk indicates
the selected language.
4. Select the desired
Remember If the synthesizer displays Rear panel HP-IB language must be 7
(111) in order to change current language the address
on the rear panel HP-IB switch (Figure 3-2) is set to something other
than 7 (all
Note If the synthesizer does not have Option 700, and you select
Power Up Language CIIL , the instrument displays
*****OPTION NOT INSTALLED*****.
5. The asterisk indicates the selected and the synthesizer
displays LANG: XXXX, ADRS=XX, REV da mo yr.
How to Select a Language on a Synthesizer without a Front Panel
If your synthesizer does not have a front panel, set the rear panel
HP-IB switch (F g
i ure 3-2) for the language you want. (See Table
for language addresses.)
Table 3-1. Language HP-IB Addresses
Language HP-IB Address
(Decimal)
0
Analyzer 1
2
3-6 INSTALLATION Specifications