HP 8360 User Manual
Page 315
SWEep : STEP value is
SWEep:TIMEMINimum
SWEep:TIME:AUTO ON
SWEep:TIME:LLIMit
SWEep :
ion
SWEep : MODE AUTO
SWEep :
:
1
0.50
SWEep:MARKer:STATe OFF
1
SYSTem:ALTernate:STATe OFF
SYSTem:COMMunicate:GPIB:ADDRess 19
SYSTem:KEY:ENABle SAVE
SYSTem:MMHead:SELect:AUTO ON
SYSTem:SECurity:COUNt 1
UNIT:AMPCT *UNIT:POWerDBM
l
The present instrument state is stored in the specified memory
register. The acceptable numeric range is from 1 to 8. An execution
error occurs if you try to save state 0.
l
l
Sets and queries the value of the Service Request Enable Register.
l
Queries the Status Byte. This is a non-destructive read.
l
This command performs the same function as the Group Execute
Trigger command defined by IEEE 488.1.
l
*TST?
A full
is performed, without data logging or looping, and
returns one of the following error codes:
Error Code
Definition
0
Test passed.
1
Test failed.
2
Test not run yet. (This is an unlikely event.)
3
Test aborted.
4
Can not execute the test.
5
Can not execute the test, test skipped.
-1
Unrecognized result, software defect.
This causes the synthesizer to wait for the pending commands to
be completed before executing any other commands. For example,
HP 8360
User’s Handbook
Operating and Programming Reference