HP 8360 - Manual (Page 427)

Preparation for Use
Power Requirements
Line Voltage and Fuse
Selection
The HP 8360 series synthesized sweepers require a power source of
o or 48 to 66 Hz, single-phase.
Power consumption is 400 VA maximum (30 VA in standby).
The synthesizer is provided with a voltage selector (located on the
rear panel) to match the synthesizer to the ac line voltage available
at the site of installation. Both the line selector and fuse were
selected at the factory to match the ac line voltage expected to be
found at the shipping destination. Verify that the voltage selector
has set to the correct line voltage before connecting power to
the synthesizer.
For continued protection against fire hazard replace line fuse only with
same type and rating. The use of other fuses or material is prohibited.
Refer to the “Routine Maintenance” chapter for information on
changing fuses.
CAUTION Before switching on this product, make sure that the line voltage
selector switch is set to the voltage of the power supply and the
correct fuse is installed. Assure the supply voltage is in the specified
range.
Specifications INSTALLATION 3-3