HP 8360 - Manual (Page 118)

Table 1-4. Sample Synthesizer Commands (continued)
HP-IB
Command Parameters
setting
coupled
output level
Parameter Type Allowed Values
extended numeric to [DB] or
Boolean
extended numeric specified power range
RF on/off Boolean
type of sweep discrete
sweep time extended numeric to 133 or
auto sweep Boolean
time switch
:LLIMit fastest sweep
time extended numeric suffix] or
Example This first program is to verify that the HP-IB connections and
1 interface are functional. Connect a controller to the synthesizer
via an HP-IB cable. Clear and reset the controller and type in the
following program:
10
20
30
40
50
60
70
80
90
ABORT 7
LOCAL Source
CLEAR Source
REMOTE Source
PRINT "The source should now be in REMOTE."
PRINT "Verify that the 'REMOTE' LED is
END
Run the program and verify that the REMOTE LED is lit on the
synthesizer. If it is not, verify that the synthesizer address is set to
19 and that the interface cable is properly connected.
If the controller display indicates an error message, it is possible that
the program was entered in incorrectly. If the controller accepts the
REMOTE statement but the synthesizer REMOTE LED does not
turn on, perform the operational checks as outlined in the respective
Operating and Service Manuals to find the defective device.
1-88 Getting Started Programming