HP 8360 - Manual (Page 351)

COMMAND SUMMARY
HP 8360
User’s Handbook
Sets and queries the save/recall register number to alternate the
foreground state of the instrument. The *RST value is 1.
l SYSTem:ALTernate:STATe
l SYSTem:ALTernate:STATe?
Sets and queries the state of the Alternate State function.
setting is OFF.
l
Changes the (General Purpose Interface Bus) address.
The *RST value is 19.
l SYSTem:DUMP:PRINter?
Causes a dump of the display contents to be made to the HP-IB.
l :
Returns the next message in the error queue. The format of the
response is :
string>
where the error number is as shown in the “Error Messages” section
and error string is :
“
specific information>”
An example response to is
-23, “NUMERIC OVERFLOW PUT IN A NUMBER TOO BIG”
l SYSTem:KEY:ASSign
This assigns the first numeric value (key code) to the second numeric
value (user menu key number). Every
menu item is given a
unique key code (as if it were a dedicated front panel key). Refer to
the entry SCPI KEY NUMBERS for a listing of key codes.
l SYSTem:KEY:CLEar
Clears the user menu. If is sent, only that particular key
number is cleared, If ALL is sent, all menu keys are cleared.
l SYSTem:KEY SAVE
The save key grouping is disabled. In our box this disables the save
state feature. (Save Lock)
SYSTem:KEY:ENABle SAVE
Unlocks the save registers. The value is for the save registers
to be enabled.
l SYSTem:LANGuage
Causes the synthesizer to perform a language switch to another
language system.
Operating and Programming Reference