HP 8360 - Manual (Page 395)

-240, Hardware error; Rear panel HP-IB switch
-224, Illegal parameter value
-222, Data out of range;Expected O-l
-222, Data out of range
-221, Settings conflict
-221, Settings conflict;List Arrays Invalid
-221, Settings conflict;Power And Level Mode
-221, Settings conflict;Power and attenuator
-221, Settings conflict;mm Module Mismatch
-220, Parameter
not allowed
-213, ignored
-200, Execution more room in EEROM
-200, Execution Not Installed
Error Messages From 199 to 100
These error messages indicate that a SCPI syntax error has been
detected by the synthesizer’s parser. An error of this type sets the
Command Error Bit (bit 5) in the Event Status Register. One of the
following events has occurred:
n A syntax error has been detected. Possible errors are: a data
element that violates the device listening formats or whose type is
unacceptable to the instrument.
A semantic error has been detected indicating that an unrecognized
header was received.
n A Group Execute Trigger (GET) was entered into the input buffer
inside a SCPI program message.
Events that generate Command Errors do not generate Execution
Errors, Device-specific Errors, or Query Errors.
-178, Expression data not allowed
-170, Expression
terminator
-161, Invalid block data;Bad terminator
-160, Block data error
-160, Block data
block type
-151, Invalid string data;Bad terminator
-144, Character data too
chars
-141, Invalid character data;Bad char in token
-138, Suffix not allowed
-131, Invalid suffix;This one not allowed
-123, Exponent too
number
-123, Exponent too overflow
-122, RESERVED
-121, Invalid character in number
-120, Numeric data
format
-120, Numeric data terminator
113, Undefined not allowed
-113, Undefined mnemonic
-109, Missing parameter
-108, Parameter not allowed;Too many
Error Messages