HP 8360 - Manual (Page 188)

Dblr Menu
Function Group POWER
Menu Map
Description This accesses the doubler amp mode softkeys. These
are applicable to instrument models with a doubler installed. The
doubler has an integral amplifier whose operation is controlled by the
instrument firmware. Its use depends on the frequency of operation
and on the calibration constants set at the factory. The instrument
defaults after preset to this automatic mode of operation which is
the specified operation.
in this menu will allow you to turn
the doubler amplifier always on or always off. These two modes are
unspecified operation for instruments with a doubler installed. These
have no effect on instruments without a doubler.
Doubler Amp Mode AUTO Sets the doubler amp mode to
AUTO. This is the default after
preset and must be used for specified
performance.
Doubler Amp Mode On Turns the doubler amplifier on
regardless of the frequency of
operation. Using this mode results in
unspecified performance.
Doubler
Mode Off Turns the doubler amplifier off
regardless of the frequency of
operation. Using this mode results in
unspecified performance.
Programming Codes SCPI: NONE
Analyzer: NONE
See Also listed above.
HP 8360
User’s Handbook
Operating and Programming Reference D-l