HP 8360 - Manual (Page 292)

Pulse
Function Group
Menu Map
Description
Programming Codes
See Also
Pulse
Function Group
Menu Map
Description
4
This activates the pulse modulation mode for an external
pulse source. The pulse source is connected to the PULSE INPUT
BNC connector and fed to the pulse modulator through a buffer
circuit.
When pulse modulation is in effect, the RF output is turned on
(programmed power is produced) and off
attenuation) at a
rate determined by the pulse modulation input. Pulse and amplitude
modulation can be in effect simultaneously. An asterisk next to the
key label indicates that this feature is active.
PULSe:SOURce
PULSe[:STATe]
Analyzer: function on, function off.
CONNECTORS, Pulse Menu
Operating and Programming Reference
4
This activates pulse modulation mode using the internal pulse
generator. No external connection is needed. When internal pulse
modulation is selected the PULSE INPUT BNC becomes an output
for the internally generated signal. An asterisk next to the
label indicates that this feature is active. The pulse parameters
(width, period, rate, rise time, etc.) are controlled by softkeys. See
Pulse Menu (or Menu for synthesizers with Option 002)
for a list of these softkeys.
HP 8360
User’s Handbook