HP 8360 - Manual (Page 343)

COMMAND SUMMARY
FREQ:MODE Affect on Slope
CW or LIST Rotates around 0 Hz.
or Rotates around the start frequency.
STEP
The *RST value is 0.
l POWer:SLOPe:STATe ON|OFF|l|O
l POWer:SLOPe:STATe?
Sets and queries the power slope state. *RST value is 0.
l POWer:SPAN
l POWer : SPAN?
The coupling equations for power sweep are exactly analogous to
those for frequency sweep. Power sweep is allowed to be negative,
unlike frequency sweeps. *RST value is 0.
l
l POWer:STARt?
Default units and units for query response are determined by the
command UNIT : POWer. The coupling equations for power sweep
are exactly analogous to those for frequency sweep. Power sweep is
allowed to be negative, unlike frequency sweeps.
value is 0
l POWer:STATe ON|OFF|l|O
l POWer:STATe?
Sets and queries the output power on/off state. *RST value is OFF.
l ON|OFF|l|O
l POWer:STEP:AUTO?
Sets and queries the function switch that controls how the power
step size STEP: is determined. if in the automatic
state, then the step size is 1 The *RST setting is ON.
l POWer : STEP :
l POWer : STEP : ? I
Sets and queries the power step size to be used for any node in the
power subsystem that allows UP and DOWN as parameters. Setting this
value explicitly causes POWer : STEP : AUTO OFF.
The setting is 10
l POWer:STOP
l POWer : STOP? I
Sets and queries the ending power for a power sweep. Default units
and units for query response are determined by the command
UNIT:POWer. The coupling equations for power sweep are exactly
HP 8360
User’s Handbook Operating and Programming Reference