HP 8360 - Manual (Page 444)

Manual Operation
Compatibility
The HP 8360 series synthesized sweepers are designed to be, in all
but very few cases, a complete feature
of the HP
synthesized sweepers. The most notable omissions are that the
HP 8360 series does not accept:
n line triggers (ie 50 or 60 Hz line frequency)
n an external leveling input from positive diode detectors
Front Panel Operation
The HP 8360 series uses a menu driven approach toward
accessing instrument functions versus a front panel key or shift key
sequence as with the HP
Instrument Preset Conditions. The factory defined preset conditions
for the HP 8360 series are identical to those for the HP
The HP 8360 series also allows you to define a different set of preset
conditions. Refer to “Changing the Preset Parameters,” in Chapter 1
for examples and more information. Table 3-6 illustrates the factory
instrument preset conditions for the HP 8360 series and the HP
An instrument preset turns off all the functions and then
sets the following:
Table 3-6.
Instrument Preset Conditions for the HP
Function Condition
Sweep Mode Full Span
Sweep Continuous/Auto
Trigger Free Run
Markers All Off
Modulation Off
Size 10% of span
Status Bytes Cleared
Leveling Internal
RF Output On
Power Level 0
Power Step Size 10
Power Sweep/Slope 0
Storage Registers Retain current values
HP-IB Address Retains current value
Status Byte Mask Unchanged
Extended Status Byte Mask Unchanged
Language Mode Unchanged
INSTALLATION Specifications