HP 8360 - Manual (Page 347)

l
Queries the Data Questionable Event Register. This is a destructive
read.
l STATus:QUEStionable:NTRansition
l
Sets and queries the Negative Filter for the Data
Questionable Status Register. The STAT US : value is 0.
l STATus:QUEStionable:PTRansition
l STATus:QUEStionable:PTRansition?
Sets and queries the Positive Filter for the Data
Questionable Status Register. After STAT US : all used bits are
set to
Sweep Subsystem Interactions between dwell, sweep time, points, step size, and
frequency span are as follows:
SWEep:TIME = (5 ms +
x (SWEep:POINts 1)
FREQ:SPAN = SWEep:STEP x (SWEep:POINts 1)
HP 8360
User’s Handbook
OFF
OFF
ON
SWEep:xx:AUTO switches
TIME Switch Action
OFF No coupling between SWEep:DWELl,
SWEep:TIME and SWEep:POINts.
ON No coupling between SWEep:DWELl,
SWEep:TIME and SWEep:POINts.
OFF When SWEEP:TIME or SWEEP:POINts
are changed, SWEep:DWELl
(SWEep:TIME (SWEep:POINts 1)) 5
SWEep:DWELl is limited to 100
minimum.
ON ON = 100
SWEep:TIME 5.1 x (SWEep:POINts 1)
l SWEep:CONTrol:STATe
l SWEep:CONTrol:STATe?
Sets and queries the state of the sweep control.
OFF Normal source mode.
ON Use master slave source mode.
*RST value is OFF.
l SWEep:CONTrol:TYPE
l SWEep:CONTrol:TYPE?
Sets and queries the synthesizer, whether it is in master or slave
mode. This applies in a dual source mode. *RST value is
Operating and Programming Reference