HP 8360 - Manual (Page 371)

Mode Ramp
Programming Codes SCPI: NONE
Analyzer: NONE
See Also listed above.
“Programming Typical Measurements,” in Chapter 1.
Sweep Mode List
Function Group
Menu Map
Description
Programming Codes
See Also
SWEEP
7
This activates the step frequency list mode. To use this type
of sweep, a frequency list must have been entered, otherwise an error
message appears. In this mode, the synthesizer steps only those
frequencies defined by the frequency list. An asterisk next to the key
label indicates that this feature is active.
SCPI: FREQuency:MODE LIST
Analyzer: SN
CONNECTORS, List Menu
“Creating and Using a Frequency List,” in Chapter 1.
Sweep Mode Ramp
Function Group SWEEP
Menu Map
Description This activates the analog frequency sweep mode. Ramp
sweep mode is the factory preset state. An asterisk next to the key
label indicates that this feature is active.
HP 8360
User’s Handbook
Operating and Programming Reference