HP 8360 - Manual (Page 213)

Coupling
List Menu
“Optimizing Synthesizer Performance” in Chapter 1.
“Programming Typical Measurements” in Chapter 1.
Function Group
Menu Map
Description
Programming Codes
See Also
POWER
5
This applies flatness correction to the synthesizer RF output.
If no array has been created, pressing this key applies 0 of flatness
correction at all points. The yellow LED above the lights
when user flatness correction is on.
SCPI: CORRection[:STATe]
Analyzer: NONE
Menu
“Optimizing Synthesizer Performance” in Chapter 1.
FM Coupling
Function Group
Menu Map
Description
4
This (Option 002 only) lets you set the FM input to be
AC-coupled. If you choose AC-coupled FM, you will be modulating a
phase locked carrier. This is the specified synthesized operation. You
must modulate at a 100 rate or greater. If not, the frequency
changes caused by the modulation are inside the phase locked loop
bandwidth and the output will not be linear FM. For modulation
frequencies below 100 choose DC-coupled FM.
An asterisk next to the key label indicates that AC FM coupling is
selected. This selection is the factory preset default.
For synthesizers without Option 002, see FM .
HP 8360
User’s Handbook
Operating and Programming Reference F-l 1