HP 8360 - Manual (Page 171)

Fill Stop
where X represents a numeric value. Unless a previous entry was
made, the display indicates the synthesizer maximum frequency.
Programming Codes SCPI: NONE,see Fltaess Menu or List Menu
Analyzer: NONE
See Also Fltness Menu, List Menu
“Optimizing Synthesizer Performance” in Chapter 1.
Auto Track
Function Group POWER, USER CAL
Menu Map
Description This optimizes the tracking of the synthesizer’s output
filter to the oscillator. Use it to maximize RF power output. The
synthesizer displays:
Peaking At: XXXXX
represents frequency values. Peaking begins at the low frequency
end and steps through to the high end of the frequency range. Auto
Track is complete when the display returns to its original state. On
synthesizers without a step attenuator provide a good source match
on the RF connector. Use a power sensor or a 10
attenuator. If
a good source match is not provided, the synthesizer can
because of excessive reflections at the output.
Programming Codes SCPI: CALibration:TRACk
Analyzer: SHRP
See Also Tracking Menu
“Optimizing Synthesizer Performance” in Chapter 1.
Operating and Programming Reference HP 8360
User’s Handbook