Gasboy CFN Series Diagnostic Manual - Manual (Page 58)

GASBOY CFN Series
2-32 0021
Printout shows one or more files reconstructed - C02117 or C08331 Memory Board
Possible Cause Checks Corrective Action
Power was off and jumpers
E5, E6, and E7 were
removed. Check jumpers E5, E6, and
E7. Install jumpers E5, E6, and
E7, if they are off.
Incorrect memory board
jumper configurations. Check the E1, E2, and E3
configuration jumpers Install the jumpers correctly if
they are wrong.
Battery failure while power
was off. Check if the red battery failure
LED's are on. Go to Battery Failure
problem.
Defective memory board. None. Replace the Memory board if
the files continue to get
reconstructed.
Printout shows one or more files reconstructed - C06731 Memory Board
Possible Cause Checks Corrective Action
Switch SW1 positions 1 & 2
are open and power was off. Check switch position. Close position 1. If LED 4 is
on, open position 1 and close
2.
Batteries not installed. Check to see if B1 and B2 are
in sockets. Defective battery may have
been removed and not
replaced. Install new
batteries if needed.
Incorrect memory board
jumper settings. Check K1-K6 for proper
settings. Install the jumpers correctly if
they are wrong.
K5 and K6 are not installed
for a C04835 or C04940 CPU
PCB. Check K5 and K6. K5 and K6 must be installed
for these CPU PCB's. Install
jumpers if needed.
Batter failure while power was
off. Check if the red battery failure
LED is on. Go to battery failure problem.
Defective memory board. None. Replace the memory board if
the files continue to be
reconstructed.