Gasboy CFN Series Diagnostic Manual - Manual (Page 237)

1310 7-1
Section 7
POSTPAY - PREPAY CONSOLE
DESCRIPTION
The GASBOY Postpay-Prepay Console is used to initiate and monitor fuel and non-fuel retail
(convenience) sales at the fuel island. The unit is controlled by a microprocessor and
communicates to the GASBOY site controller via a direct RS-422 connection.
There are several models of the postpay-prepay console: Postpay-Prepay I, Postpay-Prepay IA,
Postpay-Prepay II, Postpay-Prepay IA+, and Postpay-Prepay II+. All consoles have the following
standard features:
•
Ability to control up to 16 pumps or dispensers.
•
A 20-character alphanumeric display
•
Pump status LED's which provide the operator with current information regarding the site.
•
Full-travel keys are used in the operation of the unit.
•
An ABA track 2 magnetic stripe reader for use in reading magnetic stripe cards for credit or
debit purchases.
In addition, individual console types have the following features:
Postpay-Prepay I
2-position Manager's Keyswitch, Version 1.4 or below program, power supply C05423. Works
with Site Controller I.
Postpay-Prepay IA
2-position Manager's Keyswitch, Version 1.4, 5.0, 5.1, or 5.2 program, power supply C05423,
cash drawer connector, cash drawer interface PCB, customer display connector. Works with Site
Controller I or II.
Postpay-Prepay II
4-position Manager's Keyswitch, Version 5.0, 5.1, or 5.2 program, power supply C05423, cash
drawer connector, cash drawer interface PCB, customer display connector, extra keys for non-fuel
transactions. Works only with Site Controller II.
Postpay-Prepay IA+
Upgraded CPU board C05836, Version 5.3 or above program for SCII or V1.5 or above program
for SC I, cash drawer connector (cash drawer interface PCB is not required for this console type; it
is incorporated onto the console CPU board), customer display connector, PIN pad connector,
printer connector for parallel or serial, upgraded power supply C09053, and a 2-position
Manager's keyswitch.
Postpay-Prepay II+ or CheckPoint
Upgraded CPU board C05836, Version 5.3 or above program, cash drawer connector (cash
drawer interface PCB is not required for this console type; it is incorporated onto the console CPU
board), customer display connector, PIN pad connector, printer connector for parallel or serial,
upgraded power supply C09053, extra keys for non-fuel transactions (II+ only), a fully expanded
keyboard for merchandise (Checkpoint only) and a 4-position Manager's keyswitch. Works only
with Site Controller II.
This section contains information for all console types. If you are not sure of your console type,
check the drawings on the next page. If you are still not sure, use self-test 0 to display the
software version. Accessing self-test mode is described later in this section. All + version
consoles will have software version 5.3 (SC II) or 1.5 (SC I).