Gasboy CFN Series Diagnostic Manual - Manual (Page 279)

CFN System
1310 7-43
CONSOLE IA+ AND II+ DIAGNOSTIC TESTS
The Postpay-Prepay Consoles IA+ and II+ (V1.5 for Site Controller I or V5.3 or above for Site
Controller II) can perform a number of diagnostic tests to check the operation of various
components within the unit. Tests can be performed while connected to the site controller or
totally independent of it.
Start Diagnostic Mode (With Site Controller)
1. Insert the key into the keyswitch and turn it to MANAGER.
2. Press 00/NO SALE. The console performs its own stand-alone self-test. The display shows
the current version level of the console and the self-test menu appears.
3. Select the desired test through the numeric keypad. The test selected will continue until it
automatically ends or until the 0 key is pressed.
End Diagnostic Mode (With Site Controller)
1. Press 9 while the self-test menu is displayed.
2. Turn off and remove the Manager key.
Start Diagnostic Mode (Without Site Controller) - V5.3 and above
1. Turn off power. Disconnect RS-422 loop.
2. Turn on power. Press 00/NO SALE.
End Diagnostic Mode (Without Site Controller) - V5.3 and above
1. Turn off power. Reconnect RS-422 loop.
2. Turn on power.
Diagnostic Tests
CAUTION: Do not press CLEAR/PRINT during self-test mode. This will erase the console
configuration. (V5.3 only)
0 - Display Version Number: Press the 0 key. The console redisplays the software version
number.
00 - Manager Keyswitch Test: Press the 00/NO SALE key. The console will display the position
of the manager's keyswitch (OFF, ON, SUP, or MGR). Turning the key changes the display.
Press 0 to take the console back to the self-test menu.
1 - Memory (RAM & ROM) Test: Press the 1 key. The test checks the RAM and ROM on the
CPU PCB and reports the results immediately. This test will exit to the self-test menu after a short
wait. If this test fails, the CPU PCB must be replaced and no other tests are valid.
2 - Beeper Test: Press the 2 key. The console should display Beeper test and beep repeatedly.
Press 0 to take the console back to the self-test menu.
3 - Card Reader Test: Press the 3 key. The card reader test will allow a card to be read through
the reader. At the ENTER CARD prompt, swipe the card through the reader. The card number
is shown on the display in four groups of four digits. If the card number has more than sixteen
digits, the next four groups of four are shown after you press ENTER. When all digits have been
presented, the console again gives you the prompt, ENTER CARD. Enter another card, or press
0 to take the console back to the self-test menu.