Gasboy CFN Series Diagnostic Manual - Manual (Page 421)

CFN Islander
12/26/02 13-53
Printout shows one or more files reconstructed - General
Possible Cause Checks Corrective Action
CPU jumper K5 off and/or K6
on (Islander I only). Check if jumper is on K5. Install K5 jumper or move
jumper from K6 to K5.
C04940 and C05820 require
K5 on, K6 off.
Power surge. None. Reload data. For Islander II,
try to restore data from
backup.
File sizes were changed. Check if the maximum
number of records in one or
more files was changed, in an
Islander I, either by the
CONFIG command or by a
new personality prom
download, or in an Islander II,
running the TABLE
configuration program. Re-load data. For Islander II,
try to restore data from
backup.
Printout shows one or more files reconstructed – Islander I with C08331 Memory Board
Possible Cause Checks Corrective Action
Power was off and jumpers
E5, E6, and E7 were
removed. Check jumpers E5, E6, and
E7. Install jumpers E5, E6, and
E7, if they are off.
Incorrect memory board
jumper configurations. Check the E1, E2, and E3
configuration jumpers Install the jumpers correctly if
they are wrong.
Battery failure while power
was off. Check if the red battery
failure LED's are on. Go to Battery Failure
problem.
Defective memory board. None. Replace the Memory board if
the files continue to get
reconstructed.