Gasboy CFN Series Diagnostic Manual - Manual (Page 322)

GASBOY CFN Series
10-2 0021
PREVENTATIVE MAINTENANCE
1. Approximately every three months the slide assembly should be checked for lubrication.
This time may vary due to the operating conditions of individual installations. The ball
bearing raceways should maintain a thin film of lubricating grease. Relubrication can be
accomplished by using a small amount of petroleum jelly or other type of lubricating grease.
2. Lubrication of the latch and striker plate should also be done approximately every 3 months
depending upon individual operating conditions. The striker plate located on the back of the
inner drawer assembly should maintain a film of grease at all times. If this film has been
removed, it should be replaced with a thin film of petroleum jelly or other lubricating grease.
3. To prevent damage to your cash drawer, avoid breaking rolls of coins over either the till insert
or drawer front.
REPLACEMENT INSTRUCTIONS
Remove Inner Cash Drawer From Case
1. Open the drawer.
2. Remove the cash till insert.
3. Lift inner drawer upward.
4. With inner drawer up, pull it straight out.
Replace Inner Cash Drawer
1. Engage both inner drawer slides into mating slides inside case.
2. Lift inner drawer (with slides engaged) to clear projection over both the front bottom edge of
the case and the brake plate projecting up from the case.
3. Push the inner drawer to the fully closed position (resistance is expected because ball
bearings are skidded back to operating position).