Gasboy CFN Series Diagnostic Manual - Manual (Page 260)

GASBOY CFN Series
7-24 1310
P16 & P17 - Cash Drawer 1 and 2
Switch Postpay-Prepay Console IA+ and II+
SW1 - Reset Switch
The Reset switch starts a hardware and software
reset of the CPU PCB.
Test Points
The following table lists test points which
can be found on the CPU PCB.
Configuration - Console IA+ and II+
If the console has never been configured or if its configuration has been erased, it will go into
configuration mode at power up. Otherwise, you can access configuration mode by using self-test
7. Accessing self-test mode is described later in this section. The procedure for accessing
configuration mode for the console is the same for both Site Controller I and Site Controller II;
however, the menu choices are different. The following procedure describes accessing
configuration mode. The tables that follow indicate the configuration options for consoles used
with Site Controller I and Site Controller II. The shaded column shows the default values.
To configure the console:
1. Access diagnostic mode, self-test 7, if necessary. The message ***Configuration** appears
and the display scrolls through the keystrokes needed to change the values. Then the first
option appears. If the value selected for the option is the default value, the option is
enclosed in asterisks (*). If the value is not the default, the option is enclosed in minus signs
(-).
2. Accept the defaults or change the values for any of the configuration options using the
following keys:
ENTER accepts the displayed value and displays the next configuration option.
PREV selects the currently displayed option value and displays the previous option. For
example, if you're on keyswitch type and press this key, console address is
displayed.