Gasboy CFN Series Diagnostic Manual - Manual (Page 180)

GASBOY CFN Series
5-10 03/19/04
Changing the Paper
Removing the Paper
1. Follow the procedure for accessing the printer.
2. Cut the paper where it comes off of the roll.
3. Press the PAPER FEED switch on the printer status board until all of the paper is removed
from the printer mechanism.
4. Remove the paper roll, being careful not to bend the PAPER LOW switch.
Installing the Paper
1. Insert spindle into paper roll.
2. Insert roll into holder, being careful not to bend the PAPER LOW switch.
3. Make sure the paper feeds from the back of the roll.
4. Insert the paper into the paper feed slot while pressing the PAPER FEED switch on the
printer status board.
5. Make sure the paper feeds easily out of the paper cutter.
6. Perform a short self-test.
7. Return the printer slide assembly to its normal position and lock it in place with the hex head
screw.
8. Close and lock the printer access door.
NOTE: Make sure the printer access door is drawn tight in order to insure a watertight
seal.