Panasonic NVS90E - Manual (Page 114)

ENGLISH
Before Requesting Service
Power Source
Symptom Cause Action Page
• Movie Camera does not turn
on.
►•Battery Pack is not attached. •Attach it correctly.
►•Battery Pack is not charged. •Charge it.
► •AC Adaptor is not connected. •Connect the AC Adaptor correctly to the
Movie Camera.
16
12
52
• Movie Camera turns off
soon.
►•Battery Pack is exhausted. • Use a fully charged one.
•Shooting was paused for more than
6 minutes.
•Turn in the [POWER] Switch to turn off the
Movie Camera, and then turn it out again.
•Condensation has formed inside. •Wait several hours.
12
24
110
Shooting
• No picture appears in the »•[POWER] Switch is turned in. •Turn it out. 24
Viewfinder. f
»•Lens Cap is on the Lens. • Remove it. 20
[»•The Power Save Function has been
I activated.
•Hold the Movie Camera in horizontal
position.
36
• Indication in the Viewfinder »•The Viewfinder is not extended. • Extend it. 22
are not clear. [h
»•Eyepiece Corrector is not adjusted. •Adjust it. 22
»•Lens is covered with dust or dirt. •Clean it. 50
•Shooting cannot be started. »•Tab of the inserted cassette is broken out. •Cover the tab hole with adhesive tape. 48
^•No cassette is inserted. • Insert a cassette with intact erasure
prevention tab.
20
»•Tape has reached its end. •insert a new video cassette. 20
• Date and time cannot be »•Date and time are not set.
recorded. |
•Set the date and time.
58
• Date and time are not »•[DATE/TIME] Button was not pressed. • Press the [DATE/TIME] Button. 60
»•Button-Type Battery is exhausted. • Replace it with a new CR2032-type battery. 56
Piayback
• No playback picture is
reproduced.
■ ►•[POWER] Switch is turned in. •Turn it out and press the [VTR/CAMERA]
Button so that the “VTR” Indication Lamp
lights up.
40
►•Movie Camera is not connected to the TV
set or it is connected incorrectiy.
•Connect Movie Camera to the TV set
correctly.
102
►•Wrong channel is selected on the TV set. •Select the correct channel. —
• Picture is not in colour. »•Colour adjustment on the TV set is not
I made properly.
•Adjust colour control on the TV set.
—
• Picture is not in colour or »•Tracking is not adjusted,
distorted. j
•Adjust the tracking on the Movie Camera.
44
• Picture contains noise bars. »•Cue, Review or Still Playback is being
performed.
•This is not a malfunction.
46
-114-