KEYENCE Visual KV Series - Manual (Page 166)

2.4 Instruction Details
3-142
2
Chapter 2 Instructions
■ Transferring the current counter value to data memory (DM)
Coding
Description
In step a) , the C010 current value is transferred via the internal register and stored
into DM0000, throughout the operation.
■ Transferring the contents of data memory as a setting value for a timer
Coding
Description
• In step a) , contents of DM0010 is transferred to T002 via the internal register for
use as the T002 preset value, when 0002 is ON.
• In step b) , contents of DM0011 is transferred to T002 via the internal register for
use as the T002 preset value, when 0002 is OFF.
• Although the preset value of T002 is #00010 in the above example, any value
except #00000 can be given because the preset value is changed to the speci-
fied value by turning ON/OFF 0002. Once the counter value has been changed,
the changed value will be stored until it is changed again.
• The setting values of timers and counters are reset to the original setting values
after the power is turned OFF once and then ON again.
Note 1: If an STA instruction is executed when the current value is larger than the
preset value, the current value will be changed to the preset value.
Note 2: Do not change the setting value of T002 to "#00000".
The C010 current value is transferred to DM0000.
0001
2002 C010
LDA
DM0000
STA
#09999
C010
0000
a)
Line No. Instruction Operand
0000 LDB 0001
0001 C 010 #099999 0000
0002 LD 2002
0003 LDA C010
0004 CON
0005 STA DM0000
0002
T002 0500
b)
DM0010
LDA
T002
STA
0002
0003
DM0011
LDA
T002
STA
#00010
T002
a)
Line No. Instruction Operand Line No. Instruction Operand
0000 LD 0002 0007 STA T0002
0001 LDA DM0010 0008 LD 0003
0002 CON 0009 TMR 002 #00010
0003 STA T002 0010 CON
0004 LDB 0002 0011 AND T002
0005 LDA DM0011 0012 OUT 0500
0006 CON
LDA / @LDA / STA @STA
KVNKA Chap 02_4cP.p65 08.3.11, 0:02 PM 142