Metrohm tiamo 2.4 (process analysis) - Manual (Page 816)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
800 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Stop time
Stop when the entered time has elapsed after the start of the titration
(including start conditions).
Titrando
Input range
0 - 999,999 s
Selection off
Default value off
Filling rate
Rate at which the dosing cylinder is to be filled after the titration. The
maximum filling rate depends on the cylinder volume of the exchange unit
or dosing unit used.
Titrando
Input range
0.01 - 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Input range
0.01 - 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.5.2.7 KFT Ipol - Conditioning
Tab: Method ▶ KFT Ipol ▶ Properties... ▶ Conditioning
Command name
Name of the command.
Entry 25 characters
Conditioning
Conditioning
on | off (Default value: off)
Switching conditioning on/off. If conditioning is deactivated all following
parameters are not visible.
Start drift
The determination can only be started when the currently measured drift
is lower than the Start drift entered here. In such cases, the Status dis-
played in the Run subwindow on the Single determination or Deter-
mination series tab will then switch to COND READY.