Metrohm tiamo 2.4 (process analysis) - Manual (Page 1646)

7.20 IO controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1630 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
This value is read out automatically and depends on the Type.
Unit
Display of the unit of the analog input value.
This value is read out automatically and depends on the Type.
NOTE
With the aid of the following parameters the physical values that are
applied to the analog input can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Measured value to be used when the Low level (0%) is applied as input
value.
Input range -214783648 - 214783647
Default value 0
100% Mapping
Measured value to be used when the High level (100%) is applied as
input value.
Input range -214783648 - 214783647
Default value 100
Unit
Unit of the measured value to be used.
Entry 50 characters
Default value %
7.20.7 Properties - Analog outputs
On the tab Analog outputs all outputs detected are automatically listed
in a table. For each analog output the settings can be modified.
Port
Display of the internal description of the port.
Port description
Display of the port description.
Port specification
Shows the specifications of the port.