Metrohm tiamo 2.4 (process analysis) - Manual (Page 263)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 247
Properties
NOTE
The properties are saved individually for each curve field. This means
that it is possible, e.g., to show several different curves for the same
measuring command beside one another in several curve fields.
X pos.
x-position within the permitted section.
Input range 0.0000 - (max. page width) mm
Y pos.
y-position within the permitted section.
Input range 0.0000 - (max. page height) mm
Width
Width of curve field.
Input range 0.0000 - (max. page width) mm
Height
Height of curve field.
Input range 0.0000 - (max. page height) mm
Command type
Shows the command type for which a curve is to be produced.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS
Default value DET
Command name
Name of the command for which the curve is to be produced. With not
defined all curves present in the determination with the selected Com-
mand type will be produced as default.
NOTE
In the command name, the index in the format .# must be specified
additionally (e.g. Chloride.1).