Metrohm tiamo 2.4 (process analysis) - Manual (Page 62)

2.4 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
46 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Identifica-
tion Description Commands
.LP.MEA Measured value for the last mea-
suring point in the measuring
point list in the unit of the mea-
sured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.QTY Measured value (water) for the
last measuring point in the mea-
suring point list in µg KFC, BRC
.LP.TEM Temperature for the last measur-
ing point in the measuring point
list in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.TIM Time in s until the last measuring
point in the measuring point list is
reached DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.TRN Transmission of the last measur-
ing point of the measuring point
list in % MEAS Opt, MEAS
Opt Conc, CAL
MEAS Opt
.LP.UGE Voltage at the generator elec-
trode for last measuring point of
the measuring point list in V; in
case of measurements with 756,
831: 0 = not defined, 1 = <14
V, 2 = 14 - 28 V, 3 = >28 V KFC, BRC
.LP.VOL Volume for the last measuring
point in the measuring point list
in mL DET, MET, SET,
KFT, STAT, DOS
.LPO Current absolute lift position in
mm (entry when ending the com-
mand) LIFT