Metrohm tiamo 2.4 (process analysis) - Manual (Page 1084)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1068 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Identifica-
tion Description
.LP.TEM Temperature for the last measuring point in the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.TMF Transmission factor
5.6.4.16.2 MEAS TMF - General/Hardware
Tab: Method ▶ MEAS TMF ▶ Properties… ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.