Metrohm tiamo 2.4 (process analysis) - Manual (Page 1670)

7.21 Stepping Motor Controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1654 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
7.21 Stepping Motor Controller
7.21.1 Stepping Motor Controller - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'De-
vice type' - 'Device name'
The properties of a Stepping Motor Controller are set on the following
tabs:
￭ (see Chapter 7.20.2, page 1619)
General device information such as device name, device type, serial
number, etc.
￭ (see Chapter 7.20.3, page 1620)
General settings for the IO controller.
￭ (see Chapter 7.20.4, page 1621)
Digital inputs of the IO controller.
￭ (see Chapter 7.20.5, page 1625)
Digital outputs of the IO controller.
￭ (see Chapter 7.21.6, page 1663)
Stepping motors of the IO controller.
￭ (see Chapter 6.6.3.8, page 1419)
Information on GLP tests and GLP monitoring.
7.21.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Name of device (can be freely defined by user).
Entry 50 characters
Default value Device type number_#
Device type
Display or selection of the device type.
Wrapper version
Display of the version of AdsWrapper.dll.
Firmware version
Display of the SPS firmware version on the bus controller. Combined of
the bus controller firmware and the version of the bus controller program.
AdsDll version
Display of the version of AdsDll.dll.