Metrohm tiamo 2.4 (process analysis) - Manual (Page 779)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 763
Command variables
The following command variables are generated by the SET Upol com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CBY Command status; 1 = Conditioning activated, 0 =
Conditioning deactivated
.COK Command status; 1 = Condition requirement ful-
filled, 0 = Condition requirement not fulfilled
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in
s
.DRI Current and/or last drift for drift correction in µL/min
.DSC Time for processing all start conditions in s
.DTI Time in s for drift correction (time from the start of
the titration to the end of the command)
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.EP{x}.MEA Measured value for the endpoint × (1 - 9) in the unit
of the measured value
.EP{x}.MEP Number of endpoints in the window × (1 - 9); 1 = 1
endpoint, 2 = 2 or more endpoints, 3 = EP cor-
rected with Autodrift, 4 = EP corrected with
manual drift
.EP{x}.TEM Temperature for the endpoint × (1 - 9) in °C
.EP{x}.TIM Time in s until the endpoint × (1 - 9) is reached
.EP{x}.VOL Volume for the endpoint × (1 - 9) in mL
.ETE End temperature (temperature after the command
has been processed) in °C